Sidewall belt conveyor also named large angle belt conveyor，Why does a sidewall belt conveyor run off during use? It is believed that most users who have used a corrugated edging sidewall belt conveyor have encountered such problems. Xinxiang Jinrui Machinery Factory is a professional manufacturer of belt conveyors, of which the sidewall belt conveyor（large angle belt conveyor）has always been the main product of Jin Rui Machinery Factory. When the belt conveyor is running at a large angle, the deviation of the conveyor belt is one of the common failures. There are many reasons for this failure. The main reason is that the installation accuracy is low and the daily maintenance is not done well.
In the installation process of the sidewall belt conveyor（large angle belt conveyor）, try to ensure that the head and tail drum and the middle idler are on the same centerline, and both should be parallel to each other to ensure that the mesh belt is not biased or biased. In addition, the strap connector must be connected correctly and the circumference of both sides should be equal. This is also an effective measure.

Check the coincidence of the transverse centerline of the idler roller and the longitudinal centerline of the conveyor for the sidewall belt conveyor（large angle belt conveyor）. If there is no overlap, and the deviation exceeds 3mm, adjustment should be made. It can be adjusted by using the long mounting holes on both sides of the roller group. The specific approach is to see which side the conveyor belt is on, and which side of the roller group is The belt moves in the forward direction or the other side moves back.

Check the deviation of the two planes of the head and tailstock mounting chock. If the deviation between the two planes is greater than 1mm, the two planes should be adjusted and adjusted to the same plane. For the head roller, the adjustment method is: if the conveyor belt is offset to the right side of the roller, the bearing housing on the right side of the roller should move forward, or the left bearing seat moves backward; if the conveyor belt is offset to the left side of the roller , Move the bearing housing on the left side of the cylinder with the same direction of movement; the adjustment method of the tail cylinder is opposite to that of the head cylinder.

Check the position of the material on the conveyor belt. If the material is in the cross section of the conveyor belt and is not placed in the center, it will cause deviation of the conveyor belt. If the material is biased to the right, the belt is biased to the left. Therefore, the material should be centered as much as possible, and the baffle plate can also be added, because the baffle plate can change the direction and position of the material, thereby avoiding deviations in the conveyor belt.