Belt conveyor machine is a kind of equipment for conveying materials in a continuous way. It is mainly composed of frame, conveyor belt, idler, Pulley, Screw tension device, driving device, etc. During the daily use of belt conveyor, various problems and faults may occur.How to treatment methods of these problems as follows:

1. The motor cannot be started immediately.

Cause analysis:Motor circuit fault; Low voltage; Contactor fault

Treatment method: check the circuit; Check the voltage; Check overloaded electrical appliances.

2. Motor heating .

Cause analysis: if the length of belt conveyor is too long or blocked or the running resistance increases, Which can lead to the motor overloaded;

Treatment method: measure the motor power, find out the cause of overload operation and deal with the symptoms.

3. When fully loaded, the hydraulic coupling cannot transmit the rated torque.

Cause analysis: insufficient oil injection in hydraulic coupling.

Treatment method: add oil according to the regulations. If there is a dual motor drive, use an ammeter to measure the two motors.

4. The reducer is overheated.

Cause analysis: there is too much or too little oil in the conveyor reducer; when have a long time using about the Oil . Deterioration of lubrication conditions and bearing damage.

Treatment method: add oil according to the specified amount; Clean the inside and change the engine oil in time; Repair or replace bearings and improve lubrication conditions.

5. The conveyor belt is aged and torn.

Cause analysis: The belt deviation of the conveyor for a long time will cause the belt to tear

Treatment method:adjust the deviation of the belt conveyor in time.